Time Zone: (GMT+12:00) Auckland, Wellington, Fiji, Kamchatka (Optional)īefore proceeding, unplug the NanosStation and re-locate it to the other side of you work room and connect the Power ( PoE) only i.e. On the Network tab make the following changes. Under the Wireless tab you should now be able to disable Auto Adjust to EIRP Limit which will allow you to increase the Output Power - ( Ensure you do not transmit above the legal EIRP for your Frequency ). If you need to increase the Output Power above 20dBm you must first enable Installer EIRP Control under the Advanced tab ( Change and Apply Settings). Select Change but do not Apply settings yet. Plug in the first NSM5 (Access Point) into your laptop or network and make the following changes on the Wireless tab. If this is not the case please refer to " Setup a Static IP Address on your computer". This article assumes you know how to login to a NanoStation. You should be able to follow this guide with any of the Ubiquiti AirMAX airOS Devices (Loco M, NanoStation M, NanoBridge M, AirGrid M, PowerBridge M, PicoStation M, Bullet M and the Rocket M Series). In this article we will explain the basic configuration required to configure a Wireless Point to Point WDS Bridge with a pair of Ubiquiti NanoStation M5 AP/CPE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |